详细介绍
安装 / 使用方法及开关功能(Installation method and function of switch)
(1)安装 / 使用方法(Installation method)
1)安装设备时,地面要保障水平而坚固。
(A floor is strong,and please install equipment in the place
that is a level)
2)请将设备下端的脚轮刹车锁住。
(Please run a brake of a wheel for a transfer installed in the
bottom of equipment.)
3) 请组装挡水板、接料板、送料板、出料板。
(Construction for water cover,skin out shoot,in-shoot,out-shoot.)
4) 连接电源(Please connect the power.)
5) 水阀上连接水管后后锁紧。
(Connect water hose to a ball valve,and join decreases in a band)
6) 打开电源,请确认MOTOR的旋转方向是否正确。
(ON does a switch and confirms whether revolution course of
a motor is with forword/opposite course.)
7) 确认供应水是否正常以后,按开始按钮确认滚轴旋转方向
是否正常。(I confirm whether water is normally supplied
with and press an operation button and confirm whether roller
revolution course is with normality and use.)
- 拖措及顺序方法
- 刀架前端往上翘起时:
- 因为被坚硬异物受损翘上去的,需要把凸出的部分磨平。
- 刀板盖弯曲时:
- 一般往上弯曲,刀板盖上垫付布料以后用锤子整平。
- 滚轴(主轴),刀架前端状态:
- 确认主轴钝化状态、刀架前端损坏状态,如严重需要更换。
要保持卫生上的时常清洁。清洁时不需要工具,就可以分解设备。按照设备安装程序的相反顺序,拆卸挡板后用清水清洗。
※注意事项:每天使用机械完工后用淡水清洗,*不开机时,请将设备放置在通风干燥的地方。
- 刀架前端往上翘起时: