一、电芯老化设备简介：
1.1 设备功能和原理介绍：设备采用热风强制对流加热的方式，每个腔体控制系统相对独立，以满足不同时间出入炉需求；每套加热控制系统采用双重电子式温控器控制，以保证控温精度及可靠的异常超温保护需求。
1.3 电芯老化总体结构
整机外型尺寸: (大约)长：5050mm；深：2000mm；高：2400mm。
工作室有效内尺寸： 深：1900mm；宽：1000mm；高：1800mm
A, equipment introduction:
1.1 equipment function and the principle is introduced: with the method of hot air forced convection heating, each cavity is relatively independent control system, in order to satisfy the demands of different time of charging; Each heating control system adopts double electronic thermostat control, to ensure that the temperature control precision and reliable abnormal overtemperature protection requirements.
1.3 overall structure
The machine installation dimensions: (approximately) length: 5050 mm; Deep: 2000 mm; Height: 2400 mm.
Studio in the effective size: deep: 1900 mm; Width: 1000 mm; Height: 1800 mm
Second, the equipment can adapt to the processing and product specifications
2.1 per room can be placed two stａnd for a car, at the same time let stａnd for car size: 670 mm wide; 820 mm long; 1660 mm high.
Third, equipment technical parameters
3.1 equipment 40-80 ℃ temperature range.
3.2 equipment temperature control precision is + / - 5 ℃.
3.3 equipment failure rate of 1% or less (caused by equipment failure)
3.4 equipment of furnace chamber under no-load condition from room temperature up to + 80 ℃ is less than 30 minutes.
3.5 equipment within the cavity size: 1000 * 1800 * 1900 (width * * deep).
3.6 electrical equipment: three-phase voltage 380 v, current 120 a, 30 kw power.
3.7 compressed air: 6-8 KGF/cm
3.8 wind pressure and flow rate of 716 pa / 4110 m2 / h
3.9 weight: total weight 580 kg total weight and the ratio of the load bearing area of 500 kg/M2 or less
二、设备能适应的来料和产品规格
2.1每间房可同时放置2个静置车，静置车尺寸：宽670mm；长820mm；高1660mm。
三、电芯老化设备技术参数
3.1 设备的恒温范围40-80℃。
3.2 设备的温度控制精度±5℃。
3.3 设备故障率≤1%（指由设备造成的故障）
3.4 设备的炉腔空载状态下从室温升到+80℃小于30分钟。
3.5 设备的内腔尺寸：1000*1800*1900（宽*高*深）。
3.6 设备电气：电压三相380V，电流120A， 功率30KW。
3.7 压缩空气 ： 6-8kgf/cm
3.8 风压和流量 716pa/4110m2/h
3.9 重量：总重580Kg 总重与承重面积之比≤500kg/M2
