志铭实业·燃气加热铁板烧设备操作说明

1、首先开启风机电源，检查抽风系统，正常后再进行下一步操作。

2、然后打 开火种燃气开关，按下点火按钮，查看关火孔内苗火是否点燃。

3、苗火点燃后，打开主火开关，便可正常使用。

4、zui后调整燃气开关大小至合适状态，以控制燃火器火焰强弱。

1, first open the fan power supply, check the convulsions system, on to the next step after normal operation. 

2, then open the fire gas switch, ignition button, check off the fire hole seedling fire is lit. 

3, seedling after the fire, open the main switch, fire can be normal use. 

4, adjust gas switch size to the appropriate state, to control the strength of flame combustion firearms. 

志铭实业·电加热铁板烧设备操作说明

A、首先开启风机电源，检查抽风系统，正常后再进行下一步操作。也可以暂时关闭排烟风机，等实际操作时再开启。

B、然后按下电源按钮，设备进入待机状态，按下加热启动按钮，加热系统进入加温状态，直至温度达到设定上*停止。zui后设备的加热原件会在数字温控的控制下，在上限和下限温度之间循环工作。

C、温控设定流程：首先，打开电源开关，电源灯亮，开启动挚，按SET0.5秒屏幕显示CC。

注：1、LOCK值0为kaisuo，1为闭锁，其他为出厂设置，禁止更改。
    2、PH温度上限值严禁超过380℃。
    3、将CC设定成上限下限之间的差值（即上限减去下限值）。
    4、将P设成0。
    5、SV值设定成要求值减去1/2CC值。
例：要上限100℃，下限80℃，将CC设定成20℃，P设定成0，SV设成90℃，仪表到100℃时停止工作，到80℃时开始工作。

A, first open the fan power supply, check the convulsions system, on to the next step after normal operation. Also can temporarily closed exhaust fan, such as the actual operation and open. 

B, then press the power button, the device has reached the standby mode, press the heating start button, heating heating system into the state, until the set temperature is reached on time to stop. The heating of the original equipment. Will be under the control of the digital temperature control, between the upper and lower limit temperature cycle work. 

C, set the temperature control process: first, open the power switch, the power lights, open start zhi, according to the screen display CC SET0.5 seconds. 

Note: 1, 0 to unlock the LOCK values, 1 for closure, the other as the factory Settings, change is prohibited. 
      2, PH, temperature limit do not exceed 380 ℃. 
      3, set the CC into the difference between the upper limit lower limit value (that is, the upper limit minus the lower limit value). 
      4, will be set to 0 P. 
      5, SV set values to the required value minus 1/2 cc. 
Example: to maximum of 100 ℃, the lower limit of 80 ℃, 20 ℃, your CC set to 0, P SV set to 90 ℃, the meter to the 100 ℃ when to stop working, and begins to work up to 80 ℃.